- Country of manufactureChina
- MaterialStainless steel
- Process automationSemiautomatic
The two - bladed desktop vacuum packer of DZ - 400/2T is the typical representative of the inexpensive but reliable equipment. It is necessary to refer to advantages of this car first of all simplicity and reasonableness of a design. Having weakened two screws in the lower part of the packer, by the way there are enough large, it is possible to cast away facing and to get access to all knots. As well as hatches for oil replacement are provided in the previous model in this packer.
Console management is executed on usual timers that allows to make repair in case of need in any conditions and will not cause difficulties in acquisition of spare parts. It is necessary to refer to shortcomings of simplicity only lack of the high - quality microelevator of a vacuum cover. But it does not affect reliability at all. As practice Vacuum packers of DZ - 400/2T regularly shows and trouble - free work for years. At the correct operation only in 5 - 6 years replacement of laying on the vacuum pump is required.
Quality of a zapayka at very good level. The eight - millimetric corrugated seam reliably holds vacuum.
Due to original hinged fastening of a vacuum cover it is considerably increased service life of vacuum consolidation is increased and its insignificant damage is allowed.
Packer vacuum DZM - 400
The vacuum packer of DZ - 400 is intended for packing of products without air. The floor vacuum device is widely used to vacuum packing of foodstuff. This model has the increased productivity at the expense of two welding levels in a volume chamber. An opportunity to carry out visual control through a transparent cover is given. The device is convenient in leaving and operation as its case is manufactured of stainless steel which also increases equipment service life. After packing products are reliably protected from oxidation, a mold, insects, dampness, and remain fresh for long term. The device is completed with all necessary spare parts and special vacuum oil.
Maximum pressure of vacuum ― 1,0 KPA. Length and width of a welded seam ― 400 * 10mm. Productivity of the vacuum pump ― 20 m3/hour chamber Sizes (d \ sh \ v) ― 440 * 420 * 70 (110) mm.