Method of application "RE- THERM + BIOSEPT"
The heat-insulating liquid ceramic covering "+" is put to RE-THERM with BIOSEPT by means of a spray of a high pressure (the recommended equipment - an airbrush of "Graco Mark 5") intended for paints with high viscosity, the roller or a brush. Before drawing "RE-THERM + BIOSEPT" on the concrete or plastered surface it needs to be cleared of obvious stratifications of a fungus and mold, further it is desirable to cover it previously with an acrylic primer of deep penetration or specially prepared (from working material) structure. Then it is possible to apply on this surface "RE-THERM + to BIOSEPT". When drawing by an airbrush, the covering is put for three "passes", when drawing by a brush - material is applied for 2 passes of a brush (no more 3kh) - otherwise it can lead to destruction binding and microspheres.
"RE-THERM + BIOSEPT" effectively fights against root system of fungi. Drawing "+ BIOSEPT" relieves RE-THERM of need of additional processing of the protecting design for elimination of repeated formation of a mold.
Thickness of one coat layer no more 0,5mm, time of drying of one layer makes 24 hours, with the period of polymerization of 12 hours at + 20C and relative humidity of air no more than 75. A material consumption rate, at a single-layer covering, - 0,5 liters on 1 sq.m. of a surface. Labor input of drawing a covering is commensurable with labor input of usual painting. The heat-insulating covering at its normal operation serves not less than 10-15 years.
"RE-THERM + BIOSEPT" - the product created on the basis of environmentally friendly materials is diluted with water that allows to work with it in rooms without additional ventilation.
After long storage material can be stratified on fraction - easier fraction of material tends to emerging. Carefully mix it before application for achievement of homogeneous mass.